Llavero Cruz

A palm-sized gold charm that gives a bunch of keys a little swagger. This is a flat, single-piece keyring blank rendered in warm gold, built around a raised outline border that frames a sweeping, ribbon-like channel carved through the centre. The silhouette is deliberately off-kilter: two flush platforms flare up to the right, a rounded tab drops to the lower left, and a fully integrated loop is moulded into the side ready for a split ring. The flowing cut-out reads almost like a stroke of cursive or a stylised emblem, so it works equally as an abstract fob or as a base you personalise with an initial or short name. Because the whole thing is a low, chunky slab, it is one of the most forgiving prints you can make, and it is ideal for burning down odd tag-ends of filament or trialling a new colour. Print notes • Lay it flat on the bed; no supports needed at all. • Two or three perimeters and around 20% infill give it enough heft to survive a pocket. • A metallic PLA or PETG sells the cast-pendant look; a light sanding and polish on the top face lifts it further. • Scale to taste and enlarge slightly if you want room to stamp a name inside the recessed channel. A quick market-stall seller, a party favour, or a last-minute stocking filler.