Ghost Cookie Cutter

A friendly floating ghost, ready to haunt your baking tray. This is a cookie cutter shaped as a cartoon ghost, moulded in soft pink. The outer wall traces a rounded, lumpy top — little bumps and a small central peak like a rippling sheet — that flows down into a wavy, scalloped bottom edge, the classic "floating spectre" trailing hem. Off to one side a looped arm curls outward, and set inside the outline is a separate raised stamp element that presses interior detail — the suggestion of a face or a fold — into the dough as you cut. It is a two-in-one: a clean outline cutter plus an internal imprint. Made for Halloween bakers, spooky-season parties, and kids who love decorating their own biscuits, it turns rolled sugar-cookie or gingerbread dough into a whole ghost gang in minutes. It also works with fondant and salt dough for hanging decorations. Print notes: • Use PLA or PETG and print flat on the bed, cutting edge upward, with no supports needed. • Keep the cutting wall thin (around 0.6–0.8 mm) with a wider base flange so it stays sharp yet rigid. • The interior stamp should sit slightly shallower than the outer rim so it embosses without cutting all the way through. • Hand-wash in warm water and avoid the dishwasher's heat to keep the fine edge true.