Transport Carriage(1)

A little car that rolls straight onto the baking tray. This cookie cutter is a clean vehicle silhouette — a long, low body with a raised cabin in the middle and two rounded wheel arches bulging along the base, so a finished biscuit reads instantly as a car or carriage. The walls are deep and straight with a flat cutting edge on top and a small handling tab, shown here printed in cheerful pink. It is built for transport-mad kids: road-and-vehicle birthday parties, "things that go" themed bakes, or an afternoon of biscuit decorating where every car gets its own colour of icing. It works just as well in fondant, sugarpaste, salt dough, playdough and air-dry clay. Print notes: • PLA or PETG at a 0.4 mm nozzle is ideal; print upright with the cutting edge upward and no supports. • Two or three perimeters give a rigid wall that will not flex when you press through dough. • Keep the cutting edge to one or two thin layers so it slices cleanly rather than crushing the dough. • Wash by hand in warm soapy water and dry fully; treat printed cutters as low-contact, single-session tools rather than dishwasher items. Pair it with a few other shapes for a whole traffic jam of biscuits at the next party.