CUKTECH 30 Ultra Minimalist Desktop Exoskeleton & Cable Organizer

💡 Core Features Open-Top Drop-in Design: The top is completely open. The device slides smoothly in and out along tilted rails without any physical interference. Maximized Cooling Cutouts: Large capsule-shaped cutouts on the sides and back, combined with a flow-through bottom air channel, ensure excellent heat dissipation during high-load charging and discharging. High-Precision Magnetic Split-Body: Consists of an upper cradle base and a lower cable-hiding "garage". The four corners use a magnetic/snap-fit connection, with alignment pegs featuring a pre-calculated 2.75mm tolerance for a seamless fit. Side Quick-Release Cable Clip: Features a magnetic cable clip on the right side that can be easily detached. It holds up to 4 cables simultaneously (5.6mm slot diameter, fitting most standard braided and silicone cables). 🔩 Hardware Requirements Round Magnets: 6.0mm (Diameter) x 2.5mm (Thickness). Quantity: * 8 pcs for the four corners of the top/bottom bases (Optional, as the body also features a friction snap-fit). 2 pcs for the side cable clip and its corresponding base hole (Required, otherwise the clip won't stay in place). Tip: Secure the magnets with a small drop of super glue during assembly. 🖨️ Print & Slicing Recommendations The model contains overhangs and needs to support a heavy device. Please refer to the following settings to ensure print quality and structural strength: Recommended Filament: PETG is highly recommended (heat resistant, good toughness, ideal for snap-fits and quick release). PLA works as well. Strength Settings: * Wall loops: 3 to 4 Sparse infill density: 20% - 25% Sparse infill pattern: Gyroid Support Settings: Supports are REQUIRED. Type: Tree (auto) * Style: Tree Slim * Threshold angle: 35° Surface Quality: Set Seam position to Back. This hides the layer change seams on the less visible rear side of the model. Bed Adhesion: The parts have a large footprint. It is highly recommended to thoroughly clean your textured PEI plate before printing. A Brim is usually not needed. ⚠️ Important Note: If printing with PETG, please wait for the heated bed to cool down completely to room temperature before removing the parts to avoid damaging your build plate.