Drawer Split4

Four tidy squares that put an end to the drawer-rummage. This is a simple, deep-walled organiser tray divided into a 2x2 grid of four equal compartments by a central cross wall. The outer walls run tall for a genuinely usable depth, and a small rounded tab juts from the front edge — a little pull to hook a fingertip under, or a label ledge, depending on how it's fitted. It's a clean, no-nonsense insert with an open top. It drops into desk and workshop drawers to corral small stuff: screws, fixings and washers, craft and sewing bits, earrings and small jewellery, batteries, stationery, hobby paints or game tokens. Because it's modular, you print several and line them up to fill a drawer exactly. Print notes: • Prints flat on its base with the compartments facing up — no supports required anywhere. • The walls are thin, so 2–3 perimeters give clean, rigid dividers; 10–15% infill on the base is plenty. • PLA is fine for a dry desk drawer; PETG or PP is worth it if it'll take knocks or damp in a workshop. • Scale it in X/Y to match your drawer's internal size, and re-print the set so the trays sit snug without sliding. A quick chamfer or brim helps first-layer adhesion on the tall thin walls if your bed runs cool.