Kt 1

A little flat charm with a curl to hang it by. Rendered in a soft sage green, this is a compact flat tag: a rounded-corner rectangular plaque with a slim, S-curled loop sweeping off one end so it can hook onto a keyring, a zip pull or a bag strap. Across the face sits a shallow engraved emblem — a small, minimal figure incised into the surface — giving the otherwise plain panel a focal mark rather than leaving it blank. The whole piece is low and thin, the sort of quick, cheerful print that makes a good stocking filler, a party-bag token or a personalised luggage marker. The engraved recess takes paint or a wash beautifully if you want the motif to pop against the base colour, and the curled hook means no extra findings are needed to wear it. Print notes: • Lay it flat on the bed, engraved side up — it prints support-free and the top surface comes out smooth. • The hooked loop is the weak point; add a couple of extra perimeters or a touch more infill there so it survives daily keyring use. • For a crisp engraving, drop to a 0.12–0.16mm layer height across the top layers, or run a filament swap at the recess depth for a clean two-tone effect. • PLA prints easily; PETG holds up better to pockets, keys and knocks. Small, honest and endlessly personalisable — a five-minute print that leaves the bed as a wearable keepsake.