Nazgul Ring 6

A wide, dark band with a woven cross-hatch waist and a raised sigil bump. This ring takes the ominous One-Ring / Nazgul cue and runs with it: a broad flat-profile band with polished bevelled top and bottom rails, a recessed central channel textured in a fine basket-weave cross-hatch, and a small raised node at the front where an inscription or stone could sit. Where a lot of fantasy rings shout with spikes, this one broods — the contrast between the smooth mirrored rails and the matte knurled centre is the whole effect, and it looks superb rendered in dark metal or blackened brass. It works as a wearable band, a wraith-lord cosplay accessory, a proposal-worthy geeky keepsake, or a prop on a plinth. Print notes • Resin gives the crisp basket-weave texture and the clean bevel lines its FDM counterpart would smear; it also makes a clean master for lost-wax metal casting. • Confirm sizing by measuring your finger's inner diameter and scaling the whole model uniformly — do a quick test ring first. • Print the band on its side or upright with minimal supports on the outer bevels only; keep supports off the textured channel and the inner wall. • Blacken or oxidise the recessed weave and buff the raised rails back to a shine for maximum contrast, then seal if it will be worn daily.