Chibi Dragonborn Paladin with Oath-Tome - Tabletop Miniature

A stubby dragonborn paladin stands freshly sworn-in on a round of fitted sandstone chapel floor, both short arms clamped around an oath-tome thicker than his own barrel chest, a squat bronze mace set head-down on the flagstones against one splayed three-toed foot. The chibi proportions are pushed all the way — head close to a third of him, torso a rounded barrel, hands and feet oversized, every mass a smooth primitive parted by deep rolled grooves — while the species and class markers stay strictly literal, so nobody has to ask what he is: broad drake snout with nostril slits, a short horn crown raked flat along the skull, cheek frill spines, keeled throat scutes, and a thick-based tail curled once behind his heels. Pebbled hatchling-smooth scale carries a satin glazed-stoneware sheen, deep jade shading to bottle-emerald along the spine with mint tufts on the lozenge rows and oat-sand scutes down the belly; the holy plate reads as hand-raised penny-bronze with fat dome rivets, crowns buffed bright and sage verdigris sunk in the dents; the quilted tabard is deep plum with oat-cream stitching, belling out and pooling thick onto the stone beside a dropped votive candle stub. His head is tipped slightly back, enormous honey-amber eyes wet-bright under cream horns with butterscotch tips, and the whole read is a tiny knight treating an enormous duty with total gravity — braced to recite the entire oath from memory, and not yet sure where to begin. WHAT YOU GET The figure as one uncut part, base and mace included in the same mass. Watertight and manifold mesh, 201,770 triangles. Measured at 78.261 × 89.697 × 99.999 mm, 115.77 cm³ of solid volume. PRINTING IT 264 minutes of print time measured, and about 65 g in PLA — that weight is the extruded volume multiplied by PLA density, not a figure the slicer reported. Overhanging surface measured at 9.67 per cent. Thinnest measured wall is 0.671 mm, so a scaled-down tabletop copy thins in proportion; that size was not test printed. Fits the build plate as sliced; the underside is milled broad, level and flat. ASSEMBLY None. The model was not cut, and every contact point — both foot soles, the tabard hem, the belt end, the resting tail, the lower face of the mace head — is filleted into the plinth as one body. LICENCE Buy it once and print it as often as you like for yourself, for friends and for your own table. Do not resell, redistribute or re-upload the file. Selling prints of it needs the separate commercial tier. CHANGELOG 2026-11-05 — First release. Single-part sculpt, integrated sandstone plinth.