Vampire Spawn Fledgling with Blood Jar - Tabletop Miniature

A newly turned vampire spawn clamped around a stoneware blood jar — is the jar a separate piece you glue on? No. Fledgling, crock, torn skirt and crypt-step plinth come as one closed part, and the model was never cut. Second question, the one people ask about figures like this: does anything stick out and snap off? Nothing reaches past the footprint. No cape, no coffin, no outflung arm — both elbows are jammed into her ribs, hooked claws over the rolled rim, chin tucked down so the crowded needle fangs show. She is the thrall nobody trusts with live prey yet, so she has been handed a ration jar and has decided it is hers. The sculpt is glossy anime-collectible all the way through: swept clean volumes, crisp cel-block shading edges, enormous ruby eyes with thin slit pupils, silver-white hair laid back in thick lacquer blades with ears raked under it. The vampire markers stay blunt and literal — porcelain corpse pallor, pointed ears, milk-cream fangs over plum gums, smoke-grey claw-nails stained oxblood beneath the tips. Her funeral dress is heavy amethyst taffeta in fat sweeping folds over a charcoal quilted bodice with dull brass hooks, the hem ripped into chunky tabs and soiled grave-umber. A hot magenta mourning ribbon is knotted thick as a bootlace at her throat. The jar itself is a squat sage-glazed crock, crazed all over, with a thumb-worn handle and a bitten-off wax seal. Bare soles sit flat in the grave dust of a worn crypt step, beside a pried coffin nail and the seal she chewed loose. The download is the figure as one single-part model: watertight, manifold, 202,122 triangles, measured at 77.213 × 77.221 × 100 mm and 98.1366 cm³ of solid volume. The plinth underside is milled broad and dead flat. Sliced as supplied, print time came out at 205 minutes and the model fits the build plate. The slicer profile used carries no filament density, so the 53.68 g figure is calculated from extruded volume at the density of PLA rather than reported — treat it as about that in PLA. Measured overhang across the model is 6.79%, and the thinnest wall anywhere is 0.898 mm. Scaled down to 28–32 mm heroic that wall shrinks in proportion, and no reduced print has been tested here. There is no assembly. One part, no pins, no sockets, no glue. Print it for yourself as many times as you like, in whatever you load. The file stays with you: do not share, resell or re-upload it. If you want to sell prints, a commercial-use licence is sold separately at four to five times the file price. Changelog — 2026-11-06: first release. Single-part mesh, watertight and manifold, sliced once for the figures above. Images are renders; a photograph of a finished print is still owed.