A 4

A smooth, flowing sculptural form that pools like poured fabric. Shown as an untextured blue preview, the shape reads as a soft, glossy body with a rounded head-and-shoulder mass at one end and long drapery folds fanning out and tapering to a point at the other. Two clean square sockets are cut into the upper surface, clearly a keyed mount so the piece seats onto matching pegs on a base or armature. Without surface texture the exact subject is hard to pin down; it has the silhouette of a robed or draped figure at rest, or an abstract flowing ornament. Whatever the reading, it suits a shelf statuette, a desk ornament, or a topper that drops onto a stand. The built-in sockets mean it is designed as one part of a multi-piece assembly rather than a standalone print. Because the form is broad, smooth and low-detail, it is very forgiving to reproduce, but the swept curves want a good finish. Print notes: • FDM prints well: lay the flattest face down and the drapery will bridge cleanly with minimal supports. • The smooth surface shows layer lines, so print fine (0.12mm) or plan to sand and prime for a painted finish. • Check the square sockets against your base peg size and scale the whole model to match before slicing. • Resin gives the glassiest curves if you want a display-grade finish.