Cars Carla 0

A race-ready character straight off the Pixar starting grid. This figure takes its cue from the Cars universe, an anthropomorphic racing car with spoked wheel hubs, a long swooping body and the friendly rounded styling the franchise is known for. It is shown here at a tilted three-quarter render, so the read is a little unusual, but you can pick out the two detailed wheels, the sculpted bodywork sweeping back like a low spoiler, and the smooth curved cabin that would carry the character's face. It is a natural pick for fans of the films: a bedroom shelf ornament, a birthday-cake topper or a paintable keepsake for a young motorsport enthusiast. Because the sculpt is a single solid form it holds up well as a quick print or a painted centrepiece. Print notes: • Single OBJ file; slice at around 80-120 mm along the body for a chunky desk piece. • The overhanging wheel arches and the underside of the body will need supports, so orient wheels-up or on the flattest panel to keep them light. • Resin captures the hub spokes and panel lines; FDM is fine if you plan to paint over the layer lines. • Prime in grey, block in the body colour, then pick out the wheels, glass and trim by hand.