Hiro Pose

A pint-sized cartoon hero, caught mid-tumble in a dynamic pose. This OBJ is a chibi-proportioned character figure — an oversized rounded head with two swept-back pointed ears (or a snug eared hood), a small stocky body, and stubby limbs flung out as though he has been knocked flat on his back or is floating in freefall. Chunky boots and mitt-like hands round out the toy-like silhouette. The smooth, simplified surfaces and the exaggerated head-to-body ratio give it that collectible-mascot charm — the kind of little guy you line up along a monitor stand or a shelf edge. Because the base geometry is untextured, it is a blank canvas: paint it up in bright cel-shaded colours or print it as a clean, single-tone resin display piece. Print notes: • Resin (SLA/MSLA) is the sweet spot here — the rounded, seam-free curves and tiny fingers stay crisp where FDM layer lines would fight the smooth surfaces. • The reclined pose creates overhangs everywhere, so support the outstretched arms, the trailing leg and the underside of the head, and orient the figure at a tilt to keep supports off the face. • It is a small figure: print at collectible scale (roughly 60–90mm tall), and thicken any wafer-thin sections first if you are going the FDM route. • Cure resin fully before handling — the slim limbs stay slightly flexible until they are properly post-cured.