Pluto

A floppy-eared cartoon hound stretched out for a nap, ready for your display shelf. This is a fan-tribute figure of everyone's favourite goofy Disney dog, sculpted in that unmistakable lounging pose: front paws splayed, chin low, long ears drooping and a lazy curled tail trailing behind. The render shows the piece two ways — as one seamless reclining body, or broken into its component parts (separate head, left and right ears, individual paws and torso), so you can pick whichever route suits your printer and paint plan. The modular split is the clever bit here. Printing the head, ears and paws as loose pieces means each element seats flat with almost no overhang, so you can skip supports on the tricky undercuts and glue up afterwards for crisp, clean seams. The bundled files cover both approaches: full assemblies (Body_entire, Head_Entire) for a quick one-shot print, plus the discrete Ear_L, Ear_R, Paw_L, Paw_R and Head parts for a support-light multi-piece build. It lands somewhere between a chunky desk companion and a proper collector's piece — great on a media unit, a kid's shelf or alongside other animated-classic figures. Print notes • Resin is ideal for the smooth cartoon surfaces and the crisp muzzle detail; FDM works well if you scale up past ~120 mm. • Print the split parts flat-side down to dodge supports on the ears and paws. • Seam-fill the neck and paw joins before priming for an injection-moulded look. • Prime in grey, then block in with a warm yellow-tan and gloss varnish to nail that toy-vinyl sheen.