Splintersupported

A collector figure caught mid-motion — and pre-caged in a forest of print supports. This is a render of the ready-to-slice STL, shown in resin-blue with its full support raft still attached: a dense scaffold of angled struts and a scalloped base cradling the model so it prints clean straight off the plate. Through the lattice you can make out a dynamic pose — a torso leaning back, one arm thrown out and pointing, a head tilted up — a character frozen in a theatrical, action-ready stance. Because it arrives fully supported, the hard part is done for you: no guessing at overhangs, no hand-placing struts under the arm or chin. It's aimed at collectors building a display shelf or a small diorama, where a single expressive figure carries the scene. A few pointers for a clean pull: • Built for MSLA/resin — load it as-is so the pre-set supports do their job; slice with a standard 0.05mm layer for smooth skin. • Orient it exactly as supplied; the raft and contact points are tuned to that angle. • Wash, then cure fully before you snip supports — brittle-cured resin chips cleanly, green resin tears. • Clip supports back to little nubs first, then pare and sand the witness marks so paint sits flat. Note the exact character is partly hidden under the scaffold in this preview, so treat the identity as best-guess until you slice it.