Support Impression Fenetre (1)

A simple, glossy cylindrical rod — plain, straight and purely functional. The preview shows exactly that: a smooth round column with softly domed ends and no surface detail at all. The French title translates as 'window print support', so this is almost certainly a structural part — a dowel, spacer or standoff peg that holds a window-style print panel upright or spaces it off a wall or base. Think of it as hardware rather than decoration: a leg, a pin, a support post or a rod that pairs with a matching panel or frame from the same set. On its own it is a clean cylinder you can reuse anywhere a printed peg or dowel comes in handy. Print notes • Print upright for a perfectly round cross-section, or on its side (with a brim and light supports) if you need maximum strength along the length. • High infill or solid walls make it stiff enough to act as a load-bearing standoff. • Leave a couple of tenths of a millimetre clearance if it plugs into a matching hole — printed rods tend to run slightly oversized. • Any rigid filament works; PETG or PLA+ give a good balance of stiffness and easy printing. Because it is featureless, check the diameter and length against the panel it supports before you commit to a long print.