Vase TAR 02

A squat, spotty little vessel with toes — planter meets cartoon character. Rendered in bold blue, this is the body section of a novelty character vase: a wide, open-mouthed pot with a rolled lip, a surface freckled all over with soft oval spots, and a pair of stubby rounded toes peeking out at the front of the base. The three-part download — body plus left and right legs — lets you assemble the full stumpy-legged figure, with the hollow top ready to hold pens, brushes, dried stems or a small potted plant. It is a playful desk or shelf piece — equal parts planter, pen pot and character ornament — that suits a kid's room, a craft corner, or anywhere that could use a dose of cartoon personality. Print notes: • The hollow body prints beautifully in vase/spiralise mode for a seamless single-wall pot, or as a standard multi-wall print if you want more strength. • Print the body upright on its base; the two legs are separate parts to glue on once printed. • For live plants or water, drop in a slip-in waterproof liner or seal the interior — printed walls are rarely fully watertight. • The raised spots take a contrast drybrush or a second filament colour nicely if you want them to pop.