Roaring Dragon-Hood Gremlin

A pint-sized beastie mid-roar, its head swallowed by a fanged dragon hood. Despite the routing label, this is a fully modelled little creature figurine, not a flat relief. It's a squat, big-bellied gremlin sitting back on chunky clawed feet, both stubby arms flung out. Its whole head is engulfed by an oversized dragon-mask hood — pointed ears, a knobbly horned brow and a bulging eye up top, with a gaping toothy jaw wide open below so the beast seems frozen mid-bellow. The body is covered in soft blobby scales and dimpled skin, and a stubby tail curls out behind. It's a charming, slightly grotesque character sculpt with real personality. It's a fun desk companion, a shelf mascot, a tabletop critter or a quick painting project for hobbyists who like characterful monsters. Print notes: • Print upright as a figurine; the deep open mouth is the tricky spot, so support the roof of the jaw and the underside of the hood. • Resin at 25–50 microns captures the pebbly skin texture and tooth detail best; FDM at 0.10–0.12 mm works if you split the head from the body. • The wide feet make a stable base — no separate stand needed. • Prime grey, then work a warm mid-tone all over and dry-brush the raised scales; a darker wash pooled inside the mouth pushes the roar.