Faceted Gemstone Napkin Ring

A crystalline band that catches the light from every angle. This is a slim circular ring whose entire outer wall is cut into a run of angular facets — a continuous zig-zag of little diamond and chevron planes that ripple around the circumference like the girdle of a cut gemstone. Below that faceted crown sits a neat row of square windows punched right through the band, turning the lower half into an openwork lattice you can see daylight through. The proportions — wide and shallow rather than slender — read as a napkin ring or a chunky statement bangle rather than a finger ring. It is a quick, satisfying print for a table setting, a handmade gift, or a set of matching napkin holders for a dinner party. The geometry stays neutral enough to sit happily in a modern or a rustic table alike, and a metallic filament makes the facets read as hammered brass or pewter. Print notes • Stand the ring on one flat rim so the band grows straight up — no supports needed, and the square cut-outs bridge cleanly as vertical walls. • The faceted surface hides layer lines, so this is forgiving at 0.2mm; drop to 0.12mm only if you want razor edges on the planes. • Print a quick test at your target diameter if it must slip over a specific napkin roll or wrist. • Silk or metallic PLA really sells the cut-gem look; a light sanding across the high facets adds extra sparkle.