Acanthus-Scroll Cabriole Leg

A graceful cabriole leg, S-curved and finished with acanthus scrolls top and bottom. Rather than the flat lattice panel the tags imply, this render is a slender turned-and-carved furniture leg. A square mounting block caps each end for joinery, and between them the profile sweeps in a long, elegant S-curve. Near the top a carved acanthus leaf unfurls into a tight spiral volute; the same motif answers it at the foot, where a second scroll and a small turned collar finish the taper. It is a classic period leg, the kind found under a console table, cabinet, or upholstered chair. This is for furniture makers, restorers and CNC carvers reproducing traditional pieces, or anyone wanting a decorative bracket or newel accent. Made as a matched set of four it dresses a whole table; singly it works as a wall bracket or a shelf corbel. The deep scroll relief and the fully rounded shaft are what drive the machining or print setup. Print notes • For CNC, carve as a 3D relief with a 4th-axis rotary or run front and back halves and glue, using a ball-nose bit for the volutes and a fine finishing pass on the acanthus curls. • Leave the square end blocks oversized so you have material to cut mortises or dowel holes for real joinery. • For 3D printing, stand it upright and support the outer scroll overhangs, then sand along the curve for a carved-wood feel. • Hardwoods like oak, walnut or cherry suit the traditional look; a stain sunk into the scrollwork lifts the detail.